hard to draw

[mn shutterbug]

I just filled an Extreme that I had cleaned over a week ago. I wanted to give it plenty of time to dry out. The issue I'm having is it's a lot tougher to draw thru it now. I've blown thru it as hard as I can, but that doesn't appear to help. Any suggestions?

 

[mwa102464]

Did you do a dry burn ? there really isnt anything that should make you have a tough draw unless something is stuck in the center pole tube, makes sure you blow it out really well, maybe run very hot water through it again and blow out until your able to blow it out and take a good draw again. hope this helps

 

[robl45]

is this a giant, regular, or what? did you block the airholes ? possibly there is some crud below the coil blocking the airholes if they aren't blocked on the bottom.

 

[mn shutterbug]

I ran water thru it again and blew it out again and that didn't help, so I straightened out a large paper clip and shoved that up thru the battery end and that took care of the issue.

Thanks for the advice.

 

[robl45]

i'm guessing you hit the coil with the paperclip and pushed it up slightly which probably dislodged whatever was blocking the tube.

I ran water thru it again and blew it out again and that didn't help, so I straightened out a large paper clip and shoved that up thru the battery end and that took care of the issue.

Thanks for the advice.