I just recently bought this from a buddy who only had it about a week, it worked fine for 4 days then i picked it up to hit it and it shows 0.0 ohms and when i press the button it says "no load" i am very new to vaping so i have no idea what it is. Any replies are appreciated!
Haus mod box "No Load" error message showing up
- Thread starter PuuR
- Start date
- th_trl_thread_readers 0
- Status
The kit should have come with a manual, does it mention this error?
No load could equate to no connection, or possibly an electrical short.
Check that the coil head is seated correctly, and that tank itself is properly connected to the 510 connector of the mod. It's also possible you have bad coil head. Try replacing it.
No load could equate to no connection, or possibly an electrical short.
Check that the coil head is seated correctly, and that tank itself is properly connected to the 510 connector of the mod. It's also possible you have bad coil head. Try replacing it.
no load means that there is a disconnect somewhere... normally a snapped coil or a loose screw ( if its rebuildable) orrrr.. the + pin isnt making contact...
- Status
Similar threads
- Locked
- Locked
