hello! also: IN NEED OF ASSISTANCE (ego-t/kenger ts3)

[lambchop]

Hello all!

So, I have a dilemma. After a few hours of research and tinkering, still no avail.

Last night, my set-up (Ego-t with a Kenger TS3 tank) became finnicky. It would work fine, then stop producing vapor even though the battery was still somewhat full. A little twist to the left/right seemed to work until this morning (after the battery recieved a full charge last night). Now, today, nothing. Battery is charged, I tried the "pull up center pin", cleaning with alcohol, pretty much every quick-fix method in the book I could find. My only speculation is that since the connection pin from the atomizer protrudes from the bottom of the tank a bit instead of being flush, the battery pin keeps getting pushed down. even though I tried the pull up method. nothing is working! Any help is greatly appreciated!

 

[BiLLi0]

Hello all!

So, I have a dilemma. After a few hours of research and tinkering, still no avail.

Last night, my set-up (Ego-t with a Kenger TS3 tank) became finnicky. It would work fine, then stop producing vapor even though the battery was still somewhat full. A little twist to the left/right seemed to work until this morning (after the battery recieved a full charge last night). Now, today, nothing. Battery is charged, I tried the "pull up center pin", cleaning with alcohol, pretty much every quick-fix method in the book I could find. My only speculation is that since the connection pin from the atomizer protrudes from the bottom of the tank a bit instead of being flush, the battery pin keeps getting pushed down. even though I tried the pull up method. nothing is working! Any help is greatly appreciated!

Try getting the coil pin a bit down to make contact with the battery.

 

[EBates]

Try replacing the T3 s atomizer head.
Do you have another tank you could try?

 

[lambchop]

Try replacing the T3 s atomizer head.
Do you have another tank you could try?

I was going to try this as my next step, maybe find one where the pin is flush with the bottom of the tank. Probably will just go to my the shop I bought it at and troubleshoot until the answer is there and make another purchase.

 

[lambchop]

should also mention that I screwed in an old spare Blu cart, still no luck :[