Hells Gate slow fire

[thetrucker]

Titen down the grub screws that hold the wire in the holes in the drippers----after firing a little as they loosen

up sometimes from the heat . I had trouble with my drippers and was not getting much power and come to find out

my little screws could use a little titening as a couple did loosen up.

Once I titened the screw again that hold the wire in the holes it worked really well..........

 

[Danny_uk5]

The build didn't work so I'm gonna rma it tomorrow. Thanks for your help everyone!!!

 

[thetrucker]

I'm sorry your new mod did not work as expected------sometimes life deals you a lemon.......

 

[Danny_uk5]

It's more than fine! I got some sound advice, learnt how to build coils and enjoyed myself during it all. Life may gave me a lemon but I sure as hell learnt to make lemonade!

I should've learned to stay clear of yep altogether after I got two rdas that failed on me. I'm quite convinced the guy I bought them off had clones and didn't know. But the hells gate was from a online store, same company no less, and now it's the device. Lol. With that said-

Just another thanks to the people here on the forums! And I wish you all a good day, evening or night depending on your time frame.

 

[thetrucker]

I just thought of one last ditch effort----take it to your local vape shop and ask them to

look at it. Tell them it was a gift from your Uncle..........

 

[edyle]

So I managed to build, wrap and wick the coil to 0.7. It seems OK. .. not as fast at firing as my other ecig.

I'm wondering if I've got a dead unit or if this the best it can do ??

I might go for lower ohms but I'm at a loss on how to get lower.

Are you comparing firing 2 rda's on your hellsgate to just firing one of them on your other mod?

 

[Danny_uk5]

Not in the least. I make the coils and test them using my ecig that has a built in tester!! It's a real amazing piece of tech is sigElie as you can check your ohms without firing it. I

It's the same with my VT60 in regards of testing the ohms as the VT60 pluses a small electric feed through as you replace the rda. It's also the same when I use said builds on the VT60 - thick dense clouds that fire up more or less straight away.

Then I fire it on the hells gate but the difference is remarkable. Slow to warm up and lacking the vape you'd expect. I even tried my Tibet rda and the same results apply. Yet on the other two, warm big clouds follow.

So I'm answer to your question - I'm comparing the fire rate and smoke rate between the sigElie and the hells gate. I've been into a shop where I buy my dripping juice and he's shown me a video of a super sick 0.1 ohms build on the hells gate. This guy presses the button ever so slightly and the thing explodes into smokey gate from hell. While I do not expect these results from my build, I expected the fire rate to be higher and more of a thick dense cloud, especially with two rdas, compared to my single rda on my ecig. I am convinced that the unit is defective.

But still, my thanks to you all!