Help for 0.12 Ω builds VW mods

[TehGabi]

Hi !

So , i'm going to get pre made coils that run in dual configuration at 0.12 Ω , since i'm kind of not into coil builds ; i've been searching many electronic mods that can run in between
150 or 200 watts , because super sub ohm on mechanical mods is risky .
Even though i've found many mods that can go up to 0.10 Ω in VW ,
i want to know if its okay for 0.12 Ω builds
and if it is necessary to have fewer lower ohms resistance so it's safer ;
there's some mods that go 0.05 Ω but it's in TC .

So if anyone at ecf can help on the mods , it's nice .

Thanks .

 

[NU_FTW]

Just out of curiosity, what is your current setup like. Why do you want to hit such a low number specifically?

 

[daviedog]

What mods?
What batteries?
Go Down in ohms resistance. Risk increase.
Raising resistance in a build makes it Safer..

 

[TehGabi]

Just for maximum vapor , previously had sub ohm tank , but the pre made tank coils are expensive .

 

[NU_FTW]

Just for maximum vapor , previously had sub ohm tank , but the pre made tank coils are expensive .

Ok but why so low. You can chuck mega clouds at any respectable ohms its all about how you build it. What was the exact setup of your previous device. Something is telling me (gut feeling) you were no where near this sort of setup previously and will likely not need it...something in the .25+ range would more than satisfy you is my guess. But please let us know what your previous setup was exactly. It may help in providing information going forward.

 

[daviedog]

OP may go to subforum at ecf on rebuildable atomizers.
Lots to learn..

 

[TehGabi]

HB4 batteries with a ipv3 li , but the lowest resistance is 0.10 , so it might be nice to have few lower ohms in resistance , so the mods can handle it better or safer .

 

[TehGabi]

An Ipv3 li with exo xl with hb4 batteries .

 

[NU_FTW]

HB4 batteries with a ipv3 li , but the lowest resistance is 0.10 , so it might be nice to have few lower ohms in resistance , so the mods can handle it better or safer .

You are going the wrong direction in ohms to be "safer" and better for the mod... you make no mention of your previous tank/setup

 

[TehGabi]

An Ipv3 li with exo xl with hb4 batteries .

 

[NU_FTW]

An Ipv3 li with exo xl with hb4 batteries .

If that is what you are using.. You would benefit from an RTA more than trying to go lower in ohms... and learning to build dual coils or even quads on a good RTA.. You are limited in cloud by the drop in coils you are using....

 

[Kprthevapr]

Do you care about flavor? Because you're not gonna get much with builds like that, just clouds.
If flavor is as important as clouds, you can do both with a simple build. No need for super high wattage.

I can make my car look like its on fire with this thing, with amazing flavor to boot

 

[NU_FTW]

Hell, i hated the TFV4 and but people rave about the TFV8 and its drop in coils for their clouds... Maybe you would be better off going that route. Either way I think you need to spend some time doing a bit more searching on tanks rather than just simply trying to lower ohms. It is all about how you build your coil in what fashion more than it is about the ohms in general...

 

[NU_FTW]

Do you care about flavor? Because you're not gonna get much with builds like that, just clouds.
If flavor is as important as clouds, you can do both with a simple build. No need for super high wattage.
View attachment 629415 View attachment 629413
I can make my car look like its on fire with this thing, with amazing flavor to boot

Same here with my builds!

 

[Kprthevapr]

The thing that gets me with tanks is, at such a low build the coils are cooking the juice, by the end of the tank it tastes awful.
I haven't used a tank in years, I had to borrow a mod from my hubby one day on a road trip, I used his Bellus. Honestly, it has better flavor than any of the tanks I've tried. It's a leaky beast if not wicked properly. It has since been retired

 

[TehGabi]

Okay .
Basically , i know you're trying to prevent low builds for safety , that's appreciable .
But i did mention that i'm kind of not into coils builds .
I'm going to get a Limitless rdta as well .
Also , the coils don't limit the vapor , they're SSFC coils and run 0.12 Ω in dual coils configuration ; SSFC coils are one of the best for vapor for above 0.10 Ω coils .
Below 0.10 Ω , i don't want to try , it's risky .
Furthermore , quad coils probably end up in the very low ohms , so it's even more risky .

So yeah , it's appreciable to warn about the safety , but i've been searching a safe electronic mods for dual SSFC coils and don't know what mods to choose .

Also , even if you contribute to my request , it would be nice if you or anyone can suggest low ohms VW mods .

The mods that might be nice are the Hohm Wrecker G2 , or the Fuchai 200 W .

Thanks .

 

[TehGabi]

Also , the flavor builds aren't a priority in my vape setup .

 

[NU_FTW]

Okay .
Basically , i know you're trying to prevent low builds for safety , that's appreciable .
But i did mention that i'm kind of not into coils builds .
I'm going to get a Limitless rdta as well .
Also , the coils don't limit the vapor , they're SSFC coils and run 0.12 Ω in dual coils configuration ; SSFC coils are one of the best for vapor for above 0.10 Ω coils .
Below 0.10 Ω , i don't want to try , it's risky .
Furthermore , quad coils probably end up in the very low ohms , so it's even more risky .

So yeah , it's appreciable to warn about the safety , but i've been searching a safe electronic mods for dual SSFC coils and don't know what mods to choose .

Also , even if you contribute to my request , it would be nice if you or anyone can suggest low ohms VW mods .

The mods that might be nice are the Hohm Wrecker G2 , or the Fuchai 200 W .

Thanks .

Actually Coil build does make a difference.
X CUBE Ultra - SMOK® Being with you for all great vaping time! Is a good mod. I like it (i like stainless)
I dont like premade coils but i think if you are after clouds the TFV8 Cloud Beast would be a good topper for that mod for you.. And i would suggest you look at coil builds before claiming that 4,6,8 coil builds would be unsafe. It is about gauge of wire used and how it is built that makes the difference.

Also keep in mind the AMP draw is not directly related to Ohms of the coil in a regulated mod. Instead it is about the Wattage output SO if you wanted to go 200 watts safely from start to finish in the mod i mentioned. You would need 2 - 33 Amp batteries.

 

[NU_FTW]

Made an edit after you read it.

 

[TehGabi]

Hi !

The XCube Ultra is nice , but will fire at minimum 0.10 Ω in VW .
Also , i did mention the quad coils builds that might be unsafe ,
but it's because i want nice vapor chucking builds ; many competition or vapor builds , often run with parallel coils , running between 0.07 Ω or 0.10 Ω , so that's very low .

Thanks .