I have the itaste 134 iclear X.1 I fully charged the battery and when I click the button 3 times to turn it on. It blinks red once yellow once then green once. But then I press it to hit it and it just blinks red? What am I doing wrong lol
Its the battery that came with it both ends of the battery are flatNot familiar with the 134 or the X.1. What kind of battery are you using? Is it button-top or flat-top?
I have not but when I take the battery out and put it on the charger the light on the charger indicates red when its not fully charged and then green when it is charged and the light on the charger is now green.Red says the battery is not charged. Have you read the battery with a volt meter?
I don't know what any of the means.. Lol this is my first vapThere is also supposed to be a fuse and I have no idea where and a 1.2 ohm coil minimum. Beyond that I know not.
Red may also indicate too low of a resistance on the coil or no connection to the atty?
Yes, I just pulled it all apart and cleaned everything with a q-tip and it seems to be working fine now. Thanks Robert idk if the coil wasn't tight enough or from the battery area having a little bit of oil on it but its working now! Thanks a lot!You are using the tank that came with it? The coil is screwed in the tank snugly? Pin on the tottom of the tank and down in the top on the mod are clean? I am assuming that you put the battery in properly? And that you read the directions?
I just about asked if you'd installed the battery correctly and then I completely read Robert's post above.... The positive end of the battery has an indented "collar" (to help orient the polarity.)
Sry, have never had a 134 up close and personal..... Hopefully someone can give you more insight....
Yes thank you with Roberts tips I took it all apart and cleaned it. And she's working now! ThanksI just about asked if you'd installed the battery correctly and then I completely read Robert's post above.... The positive end of the battery has an indented "collar" (to help orient the polarity.)
Sry, have never had a 134 up close and personal..... Hopefully someone can give you more insight....
Okay just kidding.. Lol it hit once and then started doing the red blinking thing again. It blinks red six timesHappy vaping.
Okay just kidding.. Lol it hit once and then started doing the red blinking thing again. It blinks red six times
It blinks red 6 times. An yes mine is the mini as wellI have a 134 mini, with the same clearo that you mentioned. Three connections you want to be sure are good (definitely not cross threaded ) and snug: 1. the clearo itself to the APV, 2. the top of the battery tube, to the VW part of the APV, and 3. the connector on the bottom of the battery tube. Also look closely at the battery itself, there might be + sign (positive, goes into the tube first), and a - sign (negative) and make sure the battery is inserted into the tube correctly. How many times does it blink red? Here's the manual for the mini, the LED operations are probably the same for the other 2 or 3 iTaste models.