Help me use my 2 stock ego-T att's for the next 20days!!!!

Status
Not open for further replies.
Hello all,

I need some advice. I have 2 atty's that came with my ego-T from Cignot....I do not get paid until the 15th of March...One atty is leaking sometimes but when it does it crazy lol. The other is clogged/hard draw.

So this morning I boiled them and will not try them till tomorrow. ATM I'm refill old Blu carto's that fit nicely on these ego-T 1000ahm batteries=). Any how I only have three used ones that i'm rotating. If the boiling does not help the leaking atty. Please advise how I can drip with this egoT atty. I have tried using a plastic dental pick with a metal tip to try and get the needle plate off....It bend the metal dental dam and I just stab in the hand when that happen =(.

So please advise me how to drip with these egoT atty's with killing my self. I have no tools, the needle nose pliers I have are to big to get in the atty. Any advice would be appreciated.
 

juicejunky

Vaping Master
ECF Veteran
Jan 22, 2011
3,745
2,799
gone
Hello all,

So please advise me how to drip with these egoT atty's with killing my self. I have no tools, the needle nose pliers I have are to big to get in the atty. Any advice would be appreciated.


Get a thin pair of needle nose pliers or surgeons clamps and yank it out. Ask a neighbor or friend to borrow some. It only takes a second. Bring it to Home Depot or Lowes and do it there.

If you still can't, drip down the gaps on the side of the needle plate. You might have to use 4-5 drops and rotate on it's sides but the juice will get to the atty. Then stove pipe it. You can use the whistle tip mouth piece, but it cools and mutes the flavor.

On your clogged one you might try sticking a needle into the top of the wick and wiggle it around a bit. That might loosen the draw. Obviously your ejuice is not getting down there.
 
Last edited:

redheadone

Vaping Master
ECF Veteran
Feb 2, 2011
3,940
2,081
North Carolina
Vicki has got a really good video over at u-tube about rewicking and removing them. Before I would do that try denture cleanser to clean them. I read a thread about and tried it and my older attys are working great. Just go buy the cheap cleanser tabs and put your attys in a cup of hot water along with the tabs. sit you atty on top of the tab. let sit for about fifteen minutes remove an rinse really well Let sit and dry really well About twenty four hours. then frip four or five drops inthe battery end of the atty and fill your cart up and put it inthe other end Wait about ten minutes and then vape it may take about four or five good draws to get it going. If this doesnt work then your atty may have had the lick. Tme for an atty burial LOL
 
Status
Not open for further replies.

Users who are viewing this thread