Help needed with my ipv3

[Evilcon666]

So, Santa came early for me this year. I got myself a new ipv3 150w tonight, after putting in some freshly charged batteries and firing it up a little bit. I noticed that my ohms and volts jump all over the place. Am I doing something wrong? How can i get it to stay consistent?

I've got a magma rda and last I checked it was a .41 build but the reading shows im at a 1.2ohms and at 6 volts is there a way to get it to stay consistent? I take a quick draw, and the voltage drops down to 4.7 and 0.9 ohms. I know that's not normal.

 

[Syndicate707]

There should be a software update for the ipv3 already. Try that and hopefully that'll fix it. There's some people with the same problems as you with the ipv3 so don't worry you're not the only one.

 

[Evilcon666]

I may have to try that, any having the same issue? I mean I expected a little drop but as drastic as this

 

[xibxang]

I know it sounds obvious, but make sure all of your atomiser screws are good and tight. You might also want to clean the 510 threads with some isopropyl alcohol/white spirit.

 

[Evilcon666]

I know it sounds obvious, but make sure all of your atomiser screws are good and tight. You might also want to clean the 510 threads with some isopropyl alcohol/white spirit.

I'll try doing that too

 

[Evilcon666]

Didn't really help. ohms and voltage doesn't stay consistent?