Help needed

[Lewis8297]

so recently I've taken the plunge into building my own coils. I've currently got a 0.6ohm Clapton in my subtank plus on a Kbox vaping at 25w. Air holes are wide open on both sides and I'm using 50/50 homemade juice at 6mg. I'm currently using Rips pancake wicking method and it's great. No dry hits whatsoever. Although the flavour and vapour production is beautiful, I get spit back and I'm not too fond of the intensely hot juice going into my mouth and the back of my throat. Also, when I tighten the tank all the way on the mod, it won't fire. So I have to have it the ever slightest bit loose, which I am also not fond off.

If theirs anyone who can shed some light on what's happening and of theirs a solution, that would be great.

Many thanks

 

[mattiem]

I can't help with your question but wanted to keep your question at the top so someone that can, will see it.

When I first got my GS-AIR I had the problem of juice popping up and into my mouth. I put a taller drip-tip with a much smaller hole on it and solved that problem.

 

[jbok]

You may need to use more cotton. From my experience loose cotton=spit-back

 

[Ryedan]

so recently I've taken the plunge into building my own coils. I've currently got a 0.6ohm Clapton in my subtank plus on a Kbox vaping at 25w. Air holes are wide open on both sides and I'm using 50/50 homemade juice at 6mg. I'm currently using Rips pancake wicking method and it's great. No dry hits whatsoever. Although the flavour and vapour production is beautiful, I get spit back and I'm not too fond of the intensely hot juice going into my mouth and the back of my throat. Also, when I tighten the tank all the way on the mod, it won't fire. So I have to have it the ever slightest bit loose, which I am also not fond off.

I can only comment on the spit back as I have no experience with the Kbox or subtank plus. When I get spit back I've found I can reduce it or eliminate it by using a larger inside diameter drip tip.

 

[hambone0424]

More cotton or drill 2 air holes on side of rba sleeve with 5/64 in drill bit right above channels where juice comes into deck i went a lil lower than half to accomadate for threads no drys or spits n if i had spit i found blowing into tank helps a little

 

[Lewis8297]

Many thanks guys, I've added more cotton and added a fresh build. As to why it was wasn't firing, it was due to the coil touching the top of the rba section, so I moved it down further. Must be the pressure of the tank being screwed onto the mod that's making the slightest bit of contact making it short out. Once again, many thanks guys!