Ok so I have learned how to oxidize and wrap my coils pretty good and I like 500 mesh with a 8/7 wrap 28 kenthal 1.3 ohms at 3.7 v on my provari after setting up my new wick and coil and working out any hotspots or shorts I get a nice even glow and I continue to oxidize a bit by pulsing the power red hot glow and so forth I then Add my juice and begin vapeing everything is good at this point but almost every time I get to work where I have no access to any of my tools or time to tinker with my coil and if my wick gets dry for any reason not tilting or tank is low I almost always get a short or hot spot and a e2 error So I empty my tank and lower down to 3 v and sure enough only my top coil is getting hot so I probe my coils and get them all glowing red again add more juice and works great a few hours later get a little bit of a dry hit and empty my tank same thing top coil and e2 error what's going on here any help or suggestions
