HELP with Kicked Silver Bullet please!!

[Oryx]

I have a Silver Bullet set up that really really frustrates me. Honestly, since I recieved my SB there has always been problems with it.

My set up goes like this:

Silver Bullet
efest 18650 3100mAh
the Kick by Evolv
Kick sleeve for SB
HH.357 510 drip atomizer 2 ohm
empire drip shield

Just from that, you can see that I dished out quite a lot of money for this set up.. It looks great but just doesn't freaking work lol

I think the problem is with the kick. When I press the fire button (with the kick installed), it will NOT fire 90 percent of the time. If I hold my ear up to the switch though, i can hear tiny pulsing clicking sounds -it might be firing nanoseconds at a time-. Now, I do understand that the kick will regulate the battery if it is low but i am experiencing this with every fully charged battery i try with it.

Ok so get rid of the kick right? Nope.. The SB by itself doesnt fire well either. I get a super weak vape without the kick (when it's working).

 

[tj99959]

The problem is probably your kick extension. Take a wire brush and lightly scrub the inside of the extension and the threads. Then apply a light film of Noalox on those surfaces. NOALOX is an acronym for NO ALuminum OXide. Your local hardware store should have it.

This is a known issue with that extension, especially the black one.

BTW, I was vaping that exact same setup earlier this evening.

 

[Oryx]

The problem is probably your kick extension. Take a wire brush and lightly scrub the inside of the extension and the threads. Then apply a light film of Noalox on those surfaces. NOALOX is an acronym for NO ALuminum OXide. Your local hardware store should have it.

This is a known issue with that extension, especially the black one.

BTW, I was vaping that exact same setup earlier this evening.

Thanks for the info! I'll definitely try that one out. And yea man it's a great set up. haha i just wanna get it to work. Thanks again!