Help with the right resistance cartos!

[martsumoto]

Hey Guys,

I want to buy some 4.5ml tanks and 35mm dual coil cartos since they are more affordable than 45mm for dct's

I have a Provape 1 which allows LR and SR cartos.
I also Have a vtube mini VV mod.

In essence I want to buy SR Cartos that I would be able to use in both mods so I don't have to buy different resistance for each of them. The vendor carries the following:

1.25 ±0.2Ω

1.5±0.2Ω

2.0±0.2Ω

2.5±0.2Ω

So which resistance would meet my criteria? I don't know which one to order...

Thank you in advance

 

[AttyPops]

SR is about 2.3 ohms these days (I'd swear it used to be different). So... either 2.0 ±0.2Ω or 2.5 ±0.2Ω but that last one could be much cooler.

IDK those mods. I'd wish you'd ask about voltage. But assuming 3.7 volts, 2.0 is probably fine. Since one is vv you can tune it. The other... well, I'm assuming the 2.0 ±0.2Ω is close enough to SR since it supports LR anyway.

1.25 ±0.2Ω & 1.5±0.2Ω have mins at 1.05 and 1.3 ohms and that's too low IMO, but it depends on the device.

Basically, buy the one that works on the non-vv device and tune the vv to match so you can vape on both.

 

[martsumoto]

Thank you, so i guess the 2.0 to 2.5 omh would be the best bet any of them right?

since one is 3.7v and the other one vv from3 v to 6 v

 

[Jason McRoy]

Thank you, so i guess the 2.0 to 2.5 omh would be the best bet any of them right?

since one is 3.7v and the other one vv from3 v to 6 v

Yes, that could work. Keep in mind that on your Vtube, due to the auto safety function of this model you will not be able to play with the entire voltage range with the 2.0ohm cart. You will with the 2.5ohm.

Someone correct me if I am wrong here.

-Jason

 

[BiancaMontgomery]

I believe you are correct.

Yes, that could work. Keep in mind that on your Vtube, due to the auto safety function of this model you will not be able to play with the entire voltage range with the 2.0ohm cart. You will with the 2.5ohm.

Someone correct me if I am wrong here.

-Jason

martsumoto, 2ohm would be my choice.

 

[kingcobra]

With a VV standard resistance is fine and IMO is the better way to go. I never liked LR anyway, and I've never tried high ones but I can't figure out why anyone would want to So the low to mid 2's work well.

 

[Unforeseen]

Moved from General E-Smoking Discussion to Assorted PV Topics - Cartomizers

 

[martsumoto]

Thank you very much guys, it was most helpful!