!!!! Help !!!!

[Neo Knoxy]

I am just starting into the world of RDAs and need help. I just bought a E-lvt mod and a Veritas duel coil rda. I know that The Veritas probably wasnt the best choice for a beginner in rebuilds but i already have it. The E-lvt runs at 5 volts or 15 watts and can only build a 1.5 ohm coils so my question is what gauge wire should i use and how many wraps should it be. Any help would be greatly appreciated. Thanks

 

[MythDrago]

Y the Veritas was not a good call for a first rda there is a good learning curve trust me I picked up the Veritas as my first and same day I went and got a plume veil so I had one to use well I figure out the veritas. First question do u have a ohms reader. Do u wanna run single coil or duels.

 

[nyiddle]

Fairly certain the E-LVT has a built-in ohm reader, but I've also heard that it often reads .1-.2 lower than it should. ALSO, it's worthwhile to invest in a good ohm reader if you're going to be building.

You can use Steam-Engine to plan out your coils. ~9 wraps (x2, assuming you want dual coils) with 30gauge kanthal (depending on how big the drill-bit you're wrapping it around is) will bring you to about 1.5 ohms.

 

[MythDrago]

Yes the elvt does have ohms reader I have the v2 but I allways like to make shure with a ohms reader and then see what the mod reads

 

[Neo Knoxy]

Well i took Myth Drago's advice and went and bought a plume veil.

 

[MythDrago]

Well i took Myth Drago's advice and went and bought a plume veil.

the plume veil is great lots of airflow options so u can set it to what you like. very easy to build on one thing to make it little easyer when u go to put your coils in put the negative in and put ur positive lead in the post opposite of the negative one you used helps keep your coil more centered and not so close to the edge.

 

[MythDrago]

been playing with my veritas clone got that working fairly well got it running a .6ohm single coil on a 4nine mech mod clone doing nice so far