Hi from Athens, Greece

[Vangelis62]

Hello to everyone from sunny Athens, Greece. Still hot here and winter refuses to come.
I'm a 2 years vapor with regulated mods up to 80W and MTL atomizers like Siren 2 and Berserker.
I recently bought an eVic Primo mini (not the SE) and flashed in the Arctic Fox firmware. So far everything runs smooth and as I started diving deeper and deeper I'm just wondering if someone in the forum has experience with internal resistance settings as well as Shunt % corrections if needed. In general I'm asking about guidance to mastering the firmware.
Best wishes to all.

 

[bombastinator]

Howdy and welcome

You’ve come to the right place
I’ve seen posts from several users who seem quite familiar with the Arctic Fox software. Sadly I am not one of them. Someone or more likely several someone’s should be along eventually though who can help. GL

 

[untar]

Kalispera ti kaneis?
Welcome to the forum! Sadly I don't use AF and can't help you with that but I'm sure a few "1337 arctic haxxorz" will be here shortly. If not you could try to post in VV/VW APV Discussion as soon as you have the privileges (takes a few posts I believe).

 

[MJCSD]

Hello and welcome to ecf

 

[Anise]

Welcome to ECF!

 

[Bradder]

You are definitely in the right place. Glad you joined us.

καλως ΗΡΘΑΤΕ!

 

[BrotherBob]

Hello to everyone from sunny Athens, Greece. Still hot here and winter refuses to come.
I'm a 2 years vapor with regulated mods up to 80W and MTL atomizers like Siren 2 and Berserker.
I recently bought an eVic Primo mini (not the SE) and flashed in the Arctic Fox firmware. So far everything runs smooth and as I started diving deeper and deeper I'm just wondering if someone in the forum has experience with internal resistance settings as well as Shunt % corrections if needed. In general I'm asking about guidance to mastering the firmware.
Best wishes to all.

Welcome and glad you joined.
Hope you find your firmware answer.

 

[somdcomputerguy]

Welcome to ECF, Vangelis62.