Hi

Status
Not open for further replies.

Lee032995

Full Member
May 3, 2020
7
4
Spinner 2 was working fine last week. It appears to be charging properly. Ive been using the same brand pre filled cartridges for months.
The pen just dont work. Turn it on, push button & it flashes a few times. Without the cart attached it stays lit when button is pushed. I’ve already pried up slightly on the center pin & also cleaned with alcohol.
 
  • Optimistic
Reactions: stols001

Lee032995

Full Member
May 3, 2020
7
4
It was given to me, not sure how much its been charged. Since I’ve had it I’ve charged maybe 8 times in 4 months. It just seemed odd that it worked fine last week & crapped out completely & suddenly. I’ll try to find manual & check out flash codes.


The manual says it flashes three times to indicate short circuit condition. Is this something that can be fixed or is it just fried?
 
  • Like
Reactions: stols001

Izan

Vaping Master
ECF Veteran
Jul 1, 2012
8,886
15,732
Mallorca, Spain
Can someone help with spinner 2 issue?

Spinner 2 was working fine last week. It appears to be charging properly. Ive been using the same brand pre filled cartridges for months.
The pen just dont work. Turn it on, push button & it flashes a few times. Without the cart attached it stays lit when button is pushed. I’ve already pried up slightly on the center pin & also cleaned with alcohol.

It was given to me, not sure how much its been charged. Since I’ve had it I’ve charged maybe 8 times in 4 months. It just seemed odd that it worked fine last week & crapped out completely & suddenly. I’ll try to find manual & check out flash codes.

The manual says it flashes three times to indicate short circuit condition. Is this something that can be fixed or is it just fried?

Hi and welcome,
It sounds like it may have an internal problem.
The spinner2 is a disposable "ego" type battery and is generally not able to be repaired.
A new one can be had for less than $25.00 and depending on the site, you could get two for that price.

Cheers
I

ETA:
I guess I don’t understand why it only acts shorted with cartridge attached.
Does the cart work on another battery?
If a cart/atomizer/topper is attached with too much force, it can crush the electrical insulators and cause a short. (snug is tight enough)
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread