high end reo compatible atomizers

[2naphish]

i'm gonna pull the trigger on one of these tonight.. a reo and atomizer that is...not worried about the cost. just wanting to get the best experience for on the go so i can limit my high end mech's and rda's on the go use...help me and you will be blessed.. (especially if you fill out the survey at the top of the page... p.s. i have coil building and battery knowledge already. peace.. <*}}}>{

 

[FACE MEAT]

If cost is not a factor, you'd be hard pressed to beat the experience given by a Grand and a Chalice.

I've been rocking an Atomic atop my LP grand for the past 48 hours and I couldn't be happier. It should be noted that there's some modding required to get most RDAs to bottom-feed, but it's fairly easy to achieve.

 

[SeaNap]

Cyclone BF AFC (Air Flow Control) it needs a LP REO to fit but its a pretty amazing atty. If you don't have a LP, a simple option is the Igo-BF that rob sells, I like that they are SS and the small chamber is great for flavor.

 

[Rickajho]

What have I done?

See here for the list and discussion regarding Reo compatible attys: http://www.e-cigarette-forum.com/forum/reos-mods/377836-reo-compatible-rbas.html

The Reomizer works so well and it's so easy to build... You could go Chalice is you want but you don't need to either. There is even an Igo that comes with a drilled center post for bottom feeding.

 

[2naphish]

If cost is not a factor, you'd be hard pressed to beat the experience given by a Grand and a Chalice.

I've been rocking an Atomic atop my LP grand for the past 48 hours and I couldn't be happier. It should be noted that there's some modding required to get most RDAs to bottom-feed, but it's fairly easy to achieve.

more please.. does the atomic need to be modded? i'd like to start out up and running and progress from there. i was wondering how the liquid would get to the coils on anything i own. Brass monkee, patriot,raijuu and a tugboat tomorrow...gonna require me to get a whole new ensemble i guess..no problem....i just need to know what works out of the box(or bag) the best so i don't have to sit all p'd off cause i don't have the right thing....

 

[super_X_drifter]

Yes, a REO grand and a chalice is incredibly hard to beat, but since you can't get a chalice, A REO grand and a bottom fed cyclone is also bad AYuss

Look at these

Don't pay any attention to that VV Grand - it's bad AYuss too but I hear their not being made anymore

A REO grand an an RM2 is also an excellent choice

Oh and here's a woodvil with a chalice. I hear their going for north of 500 on eBay

 

[doots]

i'm gonna pull the trigger on one of these tonight.. a reo and atomizer that is...not worried about the cost. just wanting to get the best experience for on the go so i can limit my high end mech's and rda's on the go use...help me and you will be blessed.. (especially if you fill out the survey at the top of the page... p.s. i have coil building and battery knowledge already. peace.. <*}}}>{

You cant go wrong with just the Grand and a RM2.. Or the Cyclone BF atty.. Both are amazing..

 

[2naphish]

a REO and chalice it is.... i'll wait a few more minutes to see if some one else chimes in...thanks...if you guys ever want go over to the other side (tubes) i love copper .....

 

[Rickajho]

a REO and chalice it is.... i'll wait a few more minutes to see if some one else chimes in...thanks...if you guys ever want go over to the other side (tubes) i love copper .....

Welp, just see what happens to your other mods versus Reo usage ratio once you get it. You can keep 'em but you might not be using 'em so much. Keep us posted. There are a few other reasons why this is a better experience than dripping when you feed on demand, instead of cooking liquids in the bottom of conventional drippers. You'll see.

 

[FACE MEAT]

more please.. does the atomic need to be modded? i'd like to start out up and running and progress from there. i was wondering how the liquid would get to the coils on anything i own. Brass monkee, patriot,raijuu and a tugboat tomorrow...gonna require me to get a whole new ensemble i guess..no problem....i just need to know what works out of the box(or bag) the best so i don't have to sit all p'd off cause i don't have the right thing....

Keep in mind that any RDA with a width greater than 15mm will require a low-profile REO.

As long as the atomizer's center (positive) post can be extracted, it can be modded to bottom-feed. Some atomizers' posts are a breeze, some are a pain in the .....

The Atomic's center post is quite easy to press out with nothing more than a screw driver and a bit of force. Once extracted, I cut a channel from the base of the post to just above where it'll protrude from the atomizer deck. 1-2 mm deep is all that's needed. This will allow liquid to travel up to the atomizer when the bottle is "squonked".

 

[2naphish]

oooohh. a challenge.. it will have it's place i am sure...love my tinkering with copper...ha ha will respond with a review...

 

[Rickajho]

oooohh. a challenge.. it will have it's place i am sure...love my tinkering with copper...ha ha will respond with a review...

See all the comments about "trash pickup day" on here, regarding how soon people sell off their other mods once the Reo arrives. We'll see...

Seriously: Guys is the Chalice one of the attys that has the bottom feed and "other" option? If so, just want to make sure you order the bottom feeding version.

 

[FACE MEAT]

Also, if you have a drill press, a small hole can be drilled through the length of the positive post to allow bottom-feeding.

Keep us updated on your progress!

 

[Filthy-Beast]

With an LP Reo you can mod your Patriot with a Dremel, here' one I did http://www.e-cigarette-forum.com/forum/reos-mods/511025-patriot-rba-mod.html


But I agree with a Chalice or Cyclone, a Divo or RM2. Cannot go wrong with any of them. The Chalice will cost more than the Reo.

 

[Un5tab1e]

See all the comments about "trash pickup day" on here, regarding how soon people sell off their other mods once the Reo arrives. We'll see...

Seriously: Guys is the Chalice one of the attys that has the bottom feed and "other" option? If so, just want to make sure you order the bottom feeding version.

The Chalice is a bf atty. I'd say you better just order an rm2 or igo from Rob though. Everything will show up together and you can vape out-of the box. If your gonna wait on a chalice to vape I'd say you'll be waiting awhile. They aren't mass produced and very hard to come by under 200 after a sale.

Sent from my HTC6500LVW using Tapatalk

 

[2naphish]

cool.. i have the reo grand in the cart.. can' seem to fid the chalice in stock.. still hunting...don't want to mod my existing rda's...

 

[super_X_drifter]

cool.. i have the reo grand in the cart.. can' seem to fid the chalice in stock.. still hunting...don't want to mod my existing rda's...

You won't find a chalice in stock. The only vendor is the maker - Mark Bugs. His last run sold out in minutes.

While you try to score one on the classies, I'd highly recommend a cyclone bottom fed from mountain oak vapors. It should tide you over until you can (if ever) find a chalice for sale

Congrats on the grand

 

[super_X_drifter]

Deleted duplicate post

 

[Rickajho]

Deleted duplicate post

aka "reserved for fat lady post"

 

[mackman]

Mountain Oak Vapor Cyclone BF: The Cyclone RBA by Vicious Ant
coupon code SYNDROME15 gets you 15% off. The total was $57.90 shipped