high power vapes

[koolmacvee]

What high power device do you use? 80w or higher. What are your experiences w/ higher watt devices.Please omit phallic references .

 

[VHRB2014]

IDK really. Iv only taking my sig150 up to 75w and found that the vape is entirely too hot for my particular oral cavity.

 

[Thrasher]

[QUOTE="koolmacvee, post: 15871609, member: 254376]Please omit phallic references .[/QUOTE]
Ummmm, what? Lol

 

[RebornLincoln06]

Please omit phallic references .

Lolwut?

Honestly, I love the sigelei 100 watt plus. You get really great clouds & a ton of flavor out of them, especially if you're built to around a .2. I highly recommend that one, but try and find one without a 'sticky button' issue. That's really my only complaint with Sigelei's.

 

[koolmacvee]

I knew that would get a RISE! Iol

 

[StonyArtichoke]

The highest I vape is about 100w at .2 beyond that is burny and way too hot.

 

[Deryan3]

[QUOTE="koolmacvee, post: 15871609, member: 254376]Please omit phallic references .

Ummmm, what? Lol[/QUOTE]

LOL.... was wondering my self....

 

[hashtag]

Sigelei 150 but I never go over 80 watts. I look at the over 100 watts as room to grow with future innovations.

 

[Oberon75]

IDK really. Iv only taking my sig150 up to 75w and found that the vape is entirely too hot for my particular oral cavity.

If it's getting too hot, might I suggest some thicker wire. A high watt vape is all about the surface area and being able to push bigger coils.

Sent from my HTC One M8 Harman/Kardon edition

 

[Cacique]

Oberon75 beat me to it. My daily set up is a Sigelei 150 with a Mutation Xv4 at 150 watts. I vape that all day long, batteries last me about 24 hours give or take and the vape is mildly warm, with big, thick clouds. Along with big airflow, you need the right coils like Oberon75 said. I'm using dual parallel coils, 24g around 3.5mm, 9 wraps and wicked thickly with JC, no dry hits unless you get careless.

 

[Wolfenstark]

With my sigelei 100w Ive had a few vapes at 60-70w but didn't see that much improvement from 45-50 watts on a dripper.
Ive been at 30 watts or lower for a while now on tanks.

 

[VHRB2014]

If it's getting too hot, might I suggest some thicker wire. A high watt vape is all about the surface area and being able to push bigger coils.

Sent from my HTC One M8 Harman/Kardon edition

Thing that`s relevant is the OP was asking about the Hobo RDA, a very small atty with coils that are maybe 1mm from the top cap.

I use 22 in one of my MX`s, :?)

 

[Finnvaper]

I have Smok's xpro m80, And it depends what wattage I use. If I am running a rda, I build normally to .1, so then it is 80 watts, but if I use my Atlantis, I prefer 50 watts.

 

[kr8mods]

I have an ipv3 that i use just at home mostly. I normally dont go past 80 watts. Unless i just want to show off lol. My normal go to build is a dual .3 ohm 24 awg kanthal around a 1.3 mm sd.

 

[Cool-breeze]

I've been using the IPv4 around 60w-80w. That's my evening cloud machine so it varies a bit. I think in these higher powered settings the coil build and how it relates to air flow takes on an entirely new level of importance. A bad build at 10w is unpleasant, bad build at 100w will choke the life out of you, ask me how I know...

 

[kr8mods]

@Cool-breeze i know the feeling ive been there to lol.

 

[Asbestos4004]

a reo at 4.2v...then at 4.0v....then at 3.9v....then at 3.8v....then at 3.7v for awhile..........then back to 4.2v

 

[Bigflyrodder]

My most powerful mod is my Duke but not really sure how hard I have pushed it as it is dial to taste with no markings or readout. I will say that on other mods I have I don't think I have gotten above like 35 for what I would consider a nice vape but I have never run a super subohm build on one either.