How do I make the draw tighter on my atty??

[snooze]

Good day all,

I have been vaping using an inferno from volcano with the magma atty. Being as it was my first set up, I thought everything was good.

Recently, I purchased a joye LR510 atty and wow, what a difference. The draw is nice and feels just like an analogue. My problem now is that after trying the joye atty, I now find that the draw on the magma is to loose and wish it could be tighter. I have a few magma's to use before I buy some better quality atty's.

So, my question is: how can I make the draw tighter on the magma atty's from Volcano??

Thanks for the help!!

 

[Katatonik]

1. You could develop something along the lines of the cone that the ego uses. Basically anything that cover's the connection between the atty and the battery. Attys have hole at the connector that allows the air to travel from outside. If you limit (but don't block) the amount of air that can go through, you'll be able to tighten the draw. I don't know if there's anything that would aesthetically fit your inferno (like the ego's cone does), but if you're creative you might be able to fashion something. If not, you could place your fingers/hand around that connection.

2. Are you dripping or using a cartridge/cartomizer? Altering the shape of the aperture (hole you're drawing from) will help. The smaller the aperture, the tighter the draw (think of the difference between using a normal straw and using a milkshake straw). Again, I don't know anything that would fit aesthetically on your dripping/cartridge, but you could fashion something (perhaps use a drip tip/ empty cart on top of your dripping).

3. Get thicker vapor. The thicker the vapor, the tighter the draw seems. That's one of the reason's the LR seems different. LR attys helps with the draw because it creates thicker vapor. A higher vg content in your liquid might help with this.