The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

How do I re prime my atomizer?

Discussion in 'New Members Forum' started by son et lumiere, Dec 30, 2009.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. son et lumiere

    son et lumiere Vaping Master ECF Veteran

    Dec 30, 2009
    I was reading that you need to re prime your atomizer, how often should I do it, and how do I do it?
  2. RedZone

    RedZone Moved On ECF Veteran

    Nov 9, 2009
    Denver, CO, USA
    When I fill carts which is rare, I always direct drip a couple of drops on the atty. The rest of the time I'm direct dripping on the atty.. Haven't lost an atty yet.
  3. nubee

    nubee Ultra Member ECF Veteran

    Jun 24, 2009
    IL, USA
    that's pretty much it....just 2-3 drops of juice on the bridge of the atty and let it stand for a few minutes.
  4. DMertz99

    DMertz99 Senior Member Verified Member ECF Veteran

    Nov 7, 2009
    After drying the atty out, I normally put 2 or 3 drops of liquid or plain PG (Propylene Glycol USP) on the mesh wick. If I'm going to use it right away, I will use a topped off cart and leave it set for about 15 minutes. Top-off with a few more drops and you're ready to go.

    Or you can just use a full cart and let it wick it's prime from the cartridge on it's own. This way takes a little longer.

    After about 4 or 5 vapes you should be good to go. I don't like to inhale the first few vapes on a fresh atomizer.

    Hope this helps.

    Edit: Your atomizers only need primed after cleaning
Thread Status:
Not open for further replies.

Share This Page