How do you handle 306 drip tips?
- Thread starter DC2
- Start date
- th_trl_thread_readers 0
- Status
DC2 - I know they can get pretty tight if left on for a few days and subjected to a few hundred heat cycles. Almost impossible to pull off with just the 306 and DT in your hand. I just screw it onto the PV and twist and jiggle in a clockwise rotation.
I have just the opposite problem. Got some LR Cisco 306s from VaporFlow with a tip and it is pretty loose. constantly have to clean up the leakage. I read somewhere that the tips for the Cisco would not fit the other 306s. Have some on the way and will see.
Yes I had the same issue w/vapor flow tip. It works but I have found the colored and twisted tips from Nhaler seem to fit better.
So, it appears there are no tips on getting these things off then?
So do you just leave them on forever then?
Because I don't see how I can get this one off without breaking the atomizer.
I tried freezing it hoping that maybe the metal would shrink more than the plastic.
But it didn't work.
So do you just leave them on forever then?
Because I don't see how I can get this one off without breaking the atomizer.
I tried freezing it hoping that maybe the metal would shrink more than the plastic.
But it didn't work.
Last edited:
I've just got one of the Delrin Healthcabin tips. Was tight has hell at first. Brute strength (but not enough to rip the connector out) seems to do the job and its loosened up considerably now just from repeated removal and refitting. I leave the atty attached to the PV to remove the tip.
Last edited:
- Status
Similar threads
