How do you travel/work with all your gear?

[Hightech Redneck]

I work in the service industry driving a van, so I have no desk to store stuff. I'm one of the guys who likes to have sveral devices and juices available at all times to avoid vapors tongue. I have tried various methods of taking my gear to work and will always store under the seat etc... to avoid heat. But thought I'd post this Lil swiss gear bag I found that works phenomenal. FYI it currently has in it 6 18650 batts, 2 mechs, 2 drippers, disruptor mod, zephyrus, 8 juices (I think), screwdriver and cotton scissors and the like. I may have forgotten something but I still have more room. It is made pretty well and helps keep the heat off my gear.

Almost forgot to mention my ipv3li and tct tank are in my pocket usually but will fit also.

Anyway how/what do you use?

 

[Hightech Redneck]

I'll take a better pic later.

 

[Alien Traveler]

No spares to work. Never needed in more than one year. If needed can charge with USP from computer.

A few days ago I've returned from 10 days trip. Took 2 mods, 3 tanks, juice and a "toolbox" with 2 screwdrivers, scissors, cotton and rubber bands (never opened it):

 

[DanJiblets]

 

[Firestorm]

I have a desk job, so I take a mechanical mod with me to work in my pocket that I keep on my desk and I stuff the side pockets of my backpack with a few bottles of juice, extra batteries, and a few atomizers. I put GP Spheroids in air tight plastic tubes and I roll up other RTAs in paper towels. I have a voltmeter in a center pocket of my backpack and a bag of tools and supplies if I need to re-wick an atomizer or clean my mod (I have other supplies if I need to recoil or perform other invasive maintenance in an emergency).

 

[edyle]

recently all I have been taking to work with me is my nemesis with a kick and 3d truehybrid, and a battery case with a spare 18650 batt, and 2 juice bottles - one a tobacco-high(18 to 24 mg/ml presumably), and the other a 50ml bottle of a ..... well, a mix of stuff, @2 to 4mg/ml (usually its a very diluted mix of some grape, watermelon, apple and other stuff).

that fits in one of the pockets of my laptop bag

 

[yuseffuhler]

I've managed to cut down on the gear I actually use, but I've acquired more stuff to tinker with. All of my gear fits in a small tool box with a carrying handle and removable drawers. I'll post a pic when I get in my shop tomorrow. I get to sit at my desk most of the day, and it just sits beside me or on my workbench. Looked through it earlier.... I have all my rebuilding supplies, cotton, 60m of various gauge kanthal, scissors, wire snips, drip tips, tanks, spare coils, spare RBA sections for my subtanks, 18650 batteries and charger, DMM and ohmmeter, around 120 to 60ml of juice, coil jigs (one of the graduated mandrel ones and a coil master). Also electrical tape, because why not.

 

[thomas l]

i grab a couple bottle of juice,spare set of battery's ivp4 and crown all fits in cup holder for work

 

[VaporDaze]

I'm a truck driver so in that tiny cab, space is extremely limited. Normally I take an istick 50w with a maganus, an arctic with a different juice and a couple small bottles of extra juice. As much as I would love to bring my mech and dripper, I'm operating a 20,000lb+ truck at highways speeds so there is no reason to risk life and limb over that.