How in the heck can you all to do this?

[cmccl]

Sheez- I am trying to build a Fatty v3. There are no videos on this but I figure you do it the same way as the Fatty v2



When I try this I end up with an absolute mess. The wick is completely shredded by the time I manage to wrap it with the wire. I tried a loop wick instead of just a piece like the video (I thought that might be easier) and still a complete mess. At this rate I am going to run out of wick and coil... HELP!!!

I thought this one looked pretty good but I broke the wires when trying to attach to the posts...

 

[ScottP]

I don't. I build on something solid like a drill bit and then put the wick through.

 

[cmccl]

I finally got the thing attached to the posts! When check the atomizer ohms on the provari it says LO. Does that mean I don't have enough wraps around the wick???

 

[Cr0tchF4i]

Yea, you're too low of an ohm so you need to add some resistance. Some people use a needle and put it in with the wick, wrap your wire around it and then pull out the needle. It'll give it just a little slack and when the juice makes it swell it'll fill in the gap. GL

 

[shroom]

You can also put some tape on the end of the wick to prevent it to unwind by the time you build a coil. Then you can cut the taped ends off.

 

[cmccl]

shroom -good idea!!!