I have a joye 510 and was wondering how many drops to put in the empty cartridge. Thanks!
how many drops of e liquid does an empty cartridge hold for the joye 510
- Thread starter girlintheworld
- Start date
- th_trl_thread_readers 0
- Status
Fill until the top of the filler material looks "mushy" which if I remember correctly was approximately 15 drops.
Sent from my HD2 using Tapatalk
Sent from my HD2 using Tapatalk
Do you know why it overfilled after only 3 drops? It flooded and poured out...is there a technique to get more drops in?
Yes, tilt it and drip a few drops in. Then turn about 90 degrees and drips a few more drops. Wait a bit. Continue doing this until the material is saturated. Then blow lightly, holding a napkin right underneath, to remove any liquid that may be in the very center, screw it on and vape!
throatkick" data-source="post: 5079753" class="bbCodeBlock bbCodeBlock--expandable bbCodeBlock--quote js-expandWatch">throatkick said:
this sounds like filling a carto and not a cart. Carts are not threaded on, they get pushed into an atty
take the filler of the cartridge out. fill it about 1/2-2/3 of the way (it will not leak out of the bottom) then put the filler back in. top it off with a few drops until its saturated but not leaky.
Last edited:
only thing id suggest is stop using carts. worst way in the world to enjoy vaping
Sometimes the material will repel the moisture when you drip it, I would grab a paper clip and with a straightened end push it down the side of the cart. Then drip your juice down the clip until you get like 5-10 drops in, remove the clip and spread the material back out before filling the rest of the way.
+1. Cartomizers are cheap, pick some up next time you make an order. They make your life SO much easier and generally provide better smoking as well.
Agreed. Even empty, any cart I ever owned wouldn't do any better than 5-6 drops without some sort of trick like that, and even still i'd end up with a pool more often than not that dropped onto my atomizer. Not that this is a bad thing, necessarily
I'm a newbie too, and I'm encountering the same problem when filling 510/eGo carts. But on my supplier's website, they are called 'clearomizers'... does that name sound familiar? Is it the same thing?
You might want to get some cartomizers and some clearomizers both -- my wife and I each prefer different ones.
WOW people she has carts she didnt ask for a dissertation on how much better cartos are........ Girlintheworld, When i used carts my preferred method was this.... take anything you can get like a paperclip bent to form a small j shape, remove the filler material it should be not fastened to the cart. At this piont you will want to drip your liquid in the cup on the cart about ten drops or until its approxamately three quarters full. I have found this best done on a desk/table mouthpiece down and the cup stood up on the table. Then at this point you will need to insert your filler to your little "pool" of liquid with say that same little paperclip. Toward the end of myself using attys/carts I picked up a pair if stainless steel sharp tip tweezers specifically for the removal/re-installation of cart filler material. The filler will absorb the liquid and you should just need to top off the filler with a few more drops until it looks moist. Attach to your atty after another drop or two of liquid on your atomizer bridge, which is that metallic arc inside the atomizer. Press the button/take a draw and you should have vapor no problemo. Good Luck. Happy Vaping.
- Status
Similar threads
- Locked
