How to test for clearomizer/atomizer short with a multimeter

[ROM 1]

If I have a short on my clearomizer, how can I test it with a multimeter? Will the ohm resistance be significantly lower than the usual 2.0-3.0 ohm reading? Or will there be no ohm reading? One other question: If I buy a Cartomizer and Atomizer Ohm Meter (pictured below), will this device let me know if there is a short? Thanks!

 

[oldbikeguy]

Yep It will say ooo if you have a direct short or it will read a bunch lower than it should if a store bought coil starts reading lots lower than new it's time to rebuild or trash it.To test with a meter go between the center pin and the bottem part of the device

 

[Jumpin' In...]

Haven't tried it yet, but this looks do-able to me:

HOW TO CHECK THE OHMS OF AN ATOMIZER USING A MULTIMETER - YouTube

 

[ROM 1]

Haven't tried it yet, but this looks do-able to me:

HOW TO CHECK THE OHMS OF AN ATOMIZER USING A MULTIMETER - YouTube

Thanks guys for the info. I will start rebuilding my coils soon. Just wanted to make sure I know how to test them before firing them up with my device.