iclear 30 now won't fire on my MVP V2

[SometimesMay]

I have NO idea what I'm doing wrong. This duo has been amazing as of yet. The performance on this thing is spectacular and everything about it is awesome.


Until I decided to clean the tank.


So I went to clean one of my iclear 30 tanks and cleaned it all out, dried it out, and then assembled it back together like I do with all of my other tanks. Screwed it back onto my MVP V2 at the same volts and watts that I'd been vaping it just twenty minutes before... and it's not firing. Did I mess something up?

My MVP V2 is set at 7.5 watts and 3.7 volts. I shifted it up to 8 watts and 4.2 volts and it still isn't firing. I checked to make sure everything was connected accurately and it is.


I don't know what could be wrong.
Any suggestions?


EDIT: Now it's firing, but it's making crackling sounds even after I release the button. Could it be a problem with liquid getting in the center?

 

[wonner]

First, make sure that the contact points on both the top of the MVP2 and the bottom of the tank are dry.

Second, there is a center pin in the bottom of the tank that must make clean contact with the MVP2 connection. Make sure that center pin is sticking out ever-so-slightly more than the outer ring. If not, use a small screwdriver to GENTLY lift it out a bit.

It is easy for that center pin to get pushed in just enough so that there is not a good contact.

NON means the MVP2 does not sense a connection of an atomizer (carto, tank, etc.).

HTH

 

[erikbal]

Sorry can't help your question but I have one thing to say...you use it in either voltage or wattage mode. You don't have to set both. Whichever one you used or set last is the mode that you're in.

Sent from my DROID4 using Tapatalk

 

[wonner]

One more possibility.

On the top of the MVP2, that outer ring can screw off. If you accidentally loosen that ring, it can prevent the tank from making contact in the center.

When you put a tank on, always make sure that outer ring is screwed down, not real tight but snug.