Just got my MVP itaste 2.0 question please?

[dockfam]

Just got my MVP and hooked it up to my Kanger T3S ... No matter what I did I couldn't get a good vape on it. I tried all different watts/volts...it sucked. I kept getting gurgling and liquid in the tip. I filled up the iclear 16 that it came with and have it on 6.5 watts....it's vaping beautifully now.

Any ideas on why my kanger won't work? Does iclear make a glass tank? I sometimes vape atomic fireball which I've heard can crack the plastic tanks.

Thanks in advance

 

[RoseB]

There are no glass iclear tanks that I know of I've got a Kanger T3S on my V1 MVP it works ok on it. If I still had my iclear16 clearos I'd use those instead. Have you looked into glass cartomizer tanks? I think you can get those to work on the MVP.

 

[Btsmokincat]

I have used an Evod, Protank 2, Mini Protank 2 and an Aerotank on my MVP2 without any issues. Maybe the connection pin on the MVP2 is pushed down and not making good connection with your T3s?

IMO, the "floating" pin not popping back up is the one and only downfall to an MVP2. Take a tiny screwdriver, paperclip, toothpick (something small) and gently wiggle the sides of the pin all the way around. I kind of wiggle and lift gently at the same time. You may not notice the pin raising but it does work if you're having connection problems.

Try the pin wiggle and hopefully your T3s will work better...

 

[PaulBHC]

I have Aspire glassomizers and a glass vivi nova on my MVP2 and like them. Both BDC.

 

[Topacka]

That's a problem with your tank, not your MVP.

 

[Tibbetts]

I have the same problem with the clearo that came with my MVP2. I attached an EVOD on it, PERFECT! Try swaping tanks.

 

[WileECoyote]

Glass carto tanks for me. My PT2 did that to my MVP but now it has magically gone away. If this happens, I have a tool I use to pull the pin from my cartomizer out a smidge. NBD.

 

[RoseB]

Glass carto tanks for me. My PT2 did that to my MVP but now it has magically gone away. If this happens, I have a tool I use to pull the pin from my cartomizer out a smidge. NBD.

I haven't had the center pin with my MVP, but know others have. Had a couple eGos that would give me issues. I used a wooden orange stick (it's a foo foo manicure tool) to lift the center plate a bit. They're super cheap and you can find them in about any store that has beauty section