I bought an iGo-w a while back and have been loving it so far. My issue is the positive post came loose in a very short time of using it. It quite possible could have been a user error on my part, but I suspect a faulty insulator. The positive post acts like it wants to fall out with a light touch. The worst part about it, is when I tighten my wire on the positive post. The screw will tighten ever so slightly, but then starts to turn with the whole screw. Causing the positive post and screw to drag my coil along with it. Then if I am not careful, will mess up my coil shape.
So far I have learned to work with it and I can build exceptional quality setups on the iGo-w. But, it's a nuisance nonetheless.
My main question is: Has anyone had this issue before on any UD iGos? And how did you fix it? Also, if anyone has any ideas let me know. I suspect it will be similar to fixing the RSST leak issues on the positive post. And the only fix that I have thought of is to pop out the positive pin and wrap it with plumber's tape.
Thanks everyone
So far I have learned to work with it and I can build exceptional quality setups on the iGo-w. But, it's a nuisance nonetheless.
My main question is: Has anyone had this issue before on any UD iGos? And how did you fix it? Also, if anyone has any ideas let me know. I suspect it will be similar to fixing the RSST leak issues on the positive post. And the only fix that I have thought of is to pop out the positive pin and wrap it with plumber's tape.
Thanks everyone
Last edited: