IGO W3 Problems

[dieselrick]

I recently purchased and built an IGO W3 dripper. I did have someone coach me thorough the process and I know it worked. Now I am unsure if its just me being new to rebuilds or what but GOOD GOD. I cant even draw on the thing without coughing ALOT. I mean this thing hits harsh and I don't particularly like the thing.


Problem 2 is when I attach it to my MVP there is no connection. Slightly irritating but I have backups. Any help is greatly appreciated like I said I'm new to rebuilding.

 

[AutoMax]

I recently purchased and built an IGO W3 dripper. I did have someone coach me thorough the process and I know it worked. Now I am unsure if its just me being new to rebuilds or what but GOOD GOD. I cant even draw on the thing without coughing ALOT. I mean this thing hits harsh and I don't particularly like the thing.


Problem 2 is when I attach it to my MVP there is no connection. Slightly irritating but I have backups. Any help is greatly appreciated like I said I'm new to rebuilding.

You probably need to give more details.
How many coils.
What type/gauge wire did you use.
What resistance.
What type of wick.
What type of juice.
What nic level.

I have the w3. With the build I'm running the vapor runs hotter. So the th is higher. But at 6mg nic it's fine.

I run 26g quad coil / cotton build on mine.

Sent from my SM-N900P using Tapatalk

 

[dieselrick]

I am using 28g wire into a dual cotton coil setup hitting at 1 Ohm. The juice I am using is a proprietary juice that is pretty high in VG. The nic level is 11 MG. I usually use 24mg 50/50 in my tanks and have no problem.

 

[classwife]

Moved to Rebuildable Atomizer Systems from the Modding Forum - Atomizer Mods

 

[k702]

the mvp shouldn't be able to fire down to 1 ohm.. I believe it's low end is 1.3.. but that's neither here nor there.. If it's working but hitting harsh then your airflow is probably off. make sure it's directly over the coil, make sure the coil is up off the deck enough that air can flow around it.

if the mvp isn't reading it make sure the pins are actually making contact.