I'm the new guy here, I have a few questions about my ego and 510

[slickcdb2000]

Hey everybody, after what seems like days of research and trying to figure out what to get I bit the bullet and bought a 510 kit and a ego T kit. I'm very happy with both of them so far, but i'm already ready to do some upgrading on it. First off are my batts 3.7? I'm wanting a lr atomizer but again not sure which route to go. I'm now dripping with my standard 510 atty on my egot batt. I'm looking for a good atty but not sure what ohm to get. What are some of the MUST HAVES?

I'm gonna make an order from freedomsmoke for some new eliquid. I bought everything off of ecigbestsave and i'm sure there eliquids are nowhere comparable to freedomsmoke from what i've heard.

So far this is everything I have, not including eliquids

510 Drip tip

• 1 of : Joye 510 Black PCC

$23.99 Shipped

• 1 of : Joye 510 Manual Starter Kit - Black

$39.99 Shipped

• 1 of : Joye eGo Cases - Black

$10.99 Shipped

• 1 of : Joye ego T (Tank) Atomizer - Black

$14.99 Shipped

• 1 of : Joye eGo, Joye 510 Cartomizers - Empty-Black

$8.99 Shipped

• 1 of : Joye eGo-T Kit - Black

$74.99 Shipped

 

[4mehealth]

I think the only thing is for LR is to be cautious. Use it only on your eGo. Apparently it can get hot enough to fry the MOSFET on the eGo. That's what I've read here. I haven't put an LR on my eGo. So I can't tell you what happens. And I believe LR would be anything less than 2.0.

I believe the 510 and eGo are regulated down to 3.2V.

 

[WomanOfHeart]

Welcome to ECF!

Your batteries are not 3.7V. They're more like 3.4V. You can use LR atties with the eGo, but I wouldn't go below 2.0Ohms. I wouldn't use LR atties with your regular 510 batteries. They really aren't mean for LR vaping and you could fry the switch.

You'll find that everyone here has their favorites for juice vendors. I usually DIY, but when I do buy juice it's either from Gourmet Vapor or VaporBomb.

I would buy more atomizers. They aren't going to last forever and you never how long they'll hold up. Some will last for a month or longer, others will only last a couple of days.

 

[hairball]

If you go with LR atomizers, you need a mod, even a 3.7v box mod, will work. LR's are not meant to be used on a proprietary battery like the eGo unless you buy one that meters out at 3.7v under load.

 

[slickcdb2000]

Now for the next question..... What is a good setup to use lr atty's? Mostly dripping while at home, i'll still carry my 510 with cartomizers with me. I'm thinking the silver bullet???

 

[4mehealth]

Any 3.7 mod will do.

And when it comes to that, it gets personal. From my pov, I went "cheap" and got the roughstack. Cheapest mod (I think). Actually, no, madvapes box mods are even cheaper.

 

[slickcdb2000]

Any 3.7 mod will do.

And when it comes to that, it gets personal. From my pov, I went "cheap" and got the roughstack. Cheapest mod (I think). Actually, no, madvapes box mods are even cheaper.

That's even better. and it's cheap!!! I think i'll go with the roughstack to start out with. Eventually go with something more advanced/nicer! But to start vaping 3.7 I think this will do just fine.

 

[4mehealth]

Just to let you know what I went with:
Maxi RS ($45)
Trustfire 18650 batts (2400 mAh) x 2 (around $10/each)
Trustfire charger ($10) **prices are estimates, I don't remember exactly)

I didn't order their kit because I didn't want all the other stuff that came with it. If you go with 6v, they have a "battery and charger" section. There you'll find the 16340 (I think?) battery and charger.

 

[JWebb]

You may want to look at the Provari, at Provape.com or Darwin at Nhaler.com they are the 2 best PV's on the market and can handle any Atty, 1.5, 18. 2.0 ohms for LR and 2.5 up for regular 510 and even high voltage atty's from Ikenvape.com at 3.5 omhs for 5 volt, 6 or even 7 volts. They are advanced techically and the Provari can read and display your battery charge, the Ohm resistance, and more, they are a little more expensive but worth every penny. The reo mini or reo Grand are the best juice fed mods and are great at reosmods.com.

 

[somuchsoma]

I think it will really benefit you to pick up a simple multimeter.

They aren't all that expensive and are pretty easy to use if you read the manual.

I work at an electronic supplier and you can pick up a decent one for $50. If you want to go really cheap you can get them at Harbour Freight/Princess Auto (canada).

FYI

 

[Sandybeach40]

Dont pay those prices you can save a lot at other vendors

 

[sam.8]

I ordered the 510 and egoT and my sweet spot seems to be the egot battery with the 510 atty and a drip tip. Love it. use the tanks or cartos while driving, rest of the time I always seem to go back to dripping.

 

[slickcdb2000]

You may want to look at the Provari, at Provape.com or Darwin at Nhaler.com they are the 2 best PV's on the market and can handle any Atty, 1.5, 18. 2.0 ohms for LR and 2.5 up for regular 510 and even high voltage atty's from Ikenvape.com at 3.5 omhs for 5 volt, 6 or even 7 volts. They are advanced techically and the Provari can read and display your battery charge, the Ohm resistance, and more, they are a little more expensive but worth every penny. The reo mini or reo Grand are the best juice fed mods and are great at reosmods.com.

Thanks, the provari and reo will probably be my next buy! I just ordered a RS to get me going in the mod world.

 

[slickcdb2000]

Dont pay those prices you can save a lot at other vendors

LOL!!!! I know that now, thanks to the forum!!!