Hi. So recently i purchased a patriot v1.2 (authentic) and i ran into a slight problem. So i was building on it this morning ( 22 gauge wire) and while i was tightening on of the negative posts, the screw head snapped and is currently stuck in the post. (Picture below). Does anyone know of a way to get it out?? I have contacted innovape but they have not responded yet so i came here to see if i could get any help quick.
In dire need of help/advise. Anything would do
- Thread starter Kahan Robinson
- Start date
- th_trl_thread_readers 0
- Status
Moved to Rebuildable Atomizer Systems from General vaping Discussion
Last edited:
There are kits available at your local auto stores that are just for this! Screw/bolt backout kits. Call around and see.
I don't think there will be a extraction drill bit small enough to drill into the screw without stripping the threads
Carb jet drill bits and screws. They go down to fractions of millimeters. You can buy a set a harbor freight even.
- Status
Similar threads
