Hi. So recently i purchased a patriot v1.2 (authentic) and i ran into a slight problem. So i was building on it this morning ( 22 gauge wire) and while i was tightening on of the negative posts, the screw head snapped and is currently stuck in the post. (Picture below). Does anyone know of a way to get it out?? I have contacted innovape but they have not responded yet so i came here to see if i could get any help quick.
Patriot v1.2 screw stuck!! Help please.
- Thread starter Kahan Robinson
- Start date
- th_trl_thread_readers 0
- Status
Ayeee that s.cks.
If you have a screw driver with a tip small enough to fit the post hole (or another small tipped tool) you could try to put a thin rubber band (bike tube etc) over it and then push the tool firmly and unscrew it.
The rubber should give you a bit of friction between the tool and the broken screw. Hopefully enough to remove it.
Good luck.
If you have a screw driver with a tip small enough to fit the post hole (or another small tipped tool) you could try to put a thin rubber band (bike tube etc) over it and then push the tool firmly and unscrew it.
The rubber should give you a bit of friction between the tool and the broken screw. Hopefully enough to remove it.
Good luck.
- Status
Similar threads
