Increased Flavored mg

Status
Not open for further replies.

TJPatt72

Senior Member
ECF Veteran
Oct 17, 2009
128
2
Tx
Thanks Scottes. Here's the post I prepared for the other thread:

I have flavored juices that I would like to make into 25mg. They range from 12mg, 16mg, and 18mg in different ml's via different flavors.

Yet to me those calculations look pretty high compared to the amount it takes to make a batch from scratch on nic. From that if I wanted to make my 10ml of 18mg flavored juice into 25mg I would have to add 2ml of 60mg (new batch 4.2ml) or 3.07ml of 48mg (new batch 5.2ml), etc. Does that sound right since we are only raising the nic content 7mg (25-18mg) which is less than 1/3 of 25mg?

If not what is the formula to calculate how much of different strenghts of nic it takes to raise a nic level of a flavored nic juice? I need to know which strenght and ml I would need to buy to raise some of these up so I can get off of analogs and then how much should be added to each mg to raise it to 25mg. I just don't want to over buy or over dose myself and I don't want to buy anymore juice since I have around 70 ml in these and it may be a while before I can cut back in nic. Rather amp them up and go from there on decreasing later.

Also if you just combined half and half in a cart of the 16mg & 18mg would that have you vaping 17mg (16+18/2)?
 

TJPatt72

Senior Member
ECF Veteran
Oct 17, 2009
128
2
Tx
Excluded-wouldn't go through with the rest: locate read before the Yet paragraph
On Scubabatdan's calculator I couldn't download the finished V7 (even allowing all in the firewall), but did his ejuce_calculatorv6.5 that was uploaded to this site & Scottes with MS Works version before the finished product. For the excel I use MS Works v8.0 to convert to a spreadsheet, but I don't want any excel on this old dino which is out of duct tape (W98se). Love all the calculator was built to do, but just want to make sure it wasn't harmed in the conversion.
 
Status
Not open for further replies.

Users who are viewing this thread