INNOKIN ENDURA V POD KIT REVIEWED BY BIGBOB2322

Bigbob2322

Vaping Master
ECF Veteran
Verified Member
  • Jul 27, 2014
    8,513
    23,485
    Schiller PK IL USA
    Hello folks and welcome back for today's review of the Endura V Pod Kit from innokin. The Endura V uses a 1200mAh internal battery with a maximum power output of 21 watts and is supplied to the device using smart wattage, the chipset reads the Ohm resistance of the pod being used and applies the proper wattage for that pod. This is a very simple and easy to use having no physical buttons to press or adjust, there is however adjustable airflow by way of a slider control with 3 airflow holes and is auto draw only. This is a perfect starter kit for a new vaper because all that's needed to get going is to charge it, fill it, adjust the airflow to your liking and then vape it.


    1720024656762.png



    COLOR CHOICES


    1720024698673.png



    IN THE BOX


    * 1pc Innokin Endura V Pod Device


    * 1pc Innokin VCAP 0.6 ohm Pod

    * 1pc User Manual


    20240702_152225.jpg



    SPECIFICATIONS-PARAMETERS


    * Pod Capacity: 2ml


    * Battery Capacity: 1200mAh

    * Power Output: Max.21W

    * Max. Output currency: 8.0A

    * Charging Spec: Type-C, DC5V/1A

    * Device Material: PCTG

    * Coil Resistance: 0.6ohm(21W)/0.8ohm(14W)/1.2ohm(12W)


    1720025024130.png



    FEATURES


    * MTL Pod Kit


    * Built-in 1200mAh Battery

    * 21W Maximum Output

    * LED Battery Indicator

    * Adjustable Airflow

    * Inhale Activation

    * Top-Fill Design


    THREE COMPATIBLE POD CHOICES



    1720027038223.png






    AFFORDABLE STARTER KIT


    1720027246218.png



    VERY GOOD FLAVOR


    1720027367034.png



    LARGE INTERNAL BATTERY


    1720027426490.png



    COLOR CODED BATTERY STRENGTH INDICATOR

    • Green means you have above 30% battery left
    • Yellow is 10-30%
    • Red is below 10%.

    1720027603031.png



    ADJUSTABLE AIRFLOW


    1720027817338.png
     
    • Like
    Reactions: Bingbong

    Bigbob2322

    Vaping Master
    ECF Veteran
    Verified Member
  • Jul 27, 2014
    8,513
    23,485
    Schiller PK IL USA
    FIRST IMPRESSIONS


    Being that this a very affordable kit that is about $10.00 I didn't expect any fancy packaging and it's packaged just like the device being simple. The first thing I noticed was that there is only 1 pod included in this kit and there should be 2 in my opinion in case, if the pod is a factory defect or a vaper didn't wait long enough for the juice to saturate the coil in the pod and burns it up that vaper is dead in the water. The included pod is a 0.6Ω and there is a 0.8Ω and 1.2Ω pod that is compatible with this device. I am so happy to see clear pods for this device.


    20240703_100736.jpg





    Aside from the displeasure of there being only 1 pod the devices are really attractive especially the blue one with what looks like metal flakes in the paint that really pop in the bright sunlight. The Endura V is almost a featherweight but not quiet, it is shirt pocket capable though. Innokin sent me the other 2 pods as well.


    20240702_151005.jpg


    20240702_151627.jpg


    20240702_152225.jpg



    The Endura V is not a thin device nor is it fat it fits in the goldilocks category being just the right size in my opinion. one side of the device has the UCB-C charge port and the other side is where the adjustable airflow is located by way of a slider control.


    20240703_070807.jpg


    20240703_075930.jpg



    The included pod comes with a sticker with remove printed on it across the bottom of the pod, don't forget to remove it before using. The pods are held in place with strong magnets as most are, there is no movement of the pod once it's installed.

    To begin testing I started charging both devices, when charging the battery strength indicator light begins flashing and turns off once a full charge is reached. both devices took less than 10 minutes to become fully charged.

    I am so happy to see top fill on these pods, to fill simply snap the mouthpiece off the pod and fill in the yellow fill port as pictured below. it's easier to snap the mouthpiece off with the pod connected to the device.


    20240703_071352.jpg


    20240703_132425.jpg


    20240703_091549.jpg


    20240703_102824.jpg
     

    Bigbob2322

    Vaping Master
    ECF Veteran
    Verified Member
  • Jul 27, 2014
    8,513
    23,485
    Schiller PK IL USA
    Just snap on the mouthpiece and wait 5-10 minutes before vaping and your all set. The mouthpiece has a oval opening and has a nice taper to it making it very comfortable to use.


    20240703_133800.jpg



    The battery strength indicator light lights up briefly while vaping. I can't begin to capture just how attractive the Blue one really is, in direct sunlight the metal flake sparkles really pop, my pictures do it no justice.


    20240703_104351.jpg


    20240703_104541.jpg



    Final impressions


    The Endura V has really impressed me with how well it performs being such a simple and affordable device that it is. All three of the pods performed well but the 1.2Ω was a bit to cool for my taste so if you like a cooler vape with a more tight draw pick one up.

    It's hard deciding my favorite between the 0.6Ω and the 0.8Ω pod, both provide enough warmth but the 0.6Ω is a bit warmer.

    The adjustable airflow performs great also and is pretty smooth. Having top fill really rounded out the pros for me as I can't find a con for the device itself other than coming with only 1 pod.

    I would like to thank Alisa and Innokin for providing the Endura V Pod Kit and I want to thank all of you that read my reviews as well. I hope everyone has a fantastic day.


    THANK YOU
    BIGBOB2322
     

    Users who are viewing this thread