ipv mini build

[JHoun90]

Had an ipv mini for a Lil while. Been doing minimum amounts of builds. Was wondering anyone has an idea of a build for it to put our 8 volts. Thanks

 

[drunkenbatman]

Heya mate, people are going to need some more information in order to make suggestions, like what atomizer you're using, as an rta is a very different beast from a dripper, etc. and what your goals are (flavor, vapor, etc.) Until then, this may be of help:

http://www.e-cigarette-forum.com/fo...4-7-information-resources-your-first-rba.html

 

[JHoun90]

Heya mate, people are going to need some more information in order to make suggestions, like what atomizer you're using, as an rta is a very different beast from a dripper, etc. and what your goals are (flavor, vapor, etc.) Until then, this may be of help:

http://www.e-cigarette-forum.com/fo...4-7-information-resources-your-first-rba.html

I have a doge rda. I am no stranger to making builds just to lazy for trials and errors lol.

 

[kartoffelfaust]

Given the IPV mini only runs to 30 watts and has a min ohm requirement of 0.5, that limits what you can do in an RDA. You'll need to build above 0.5. Single coil, that's not too hard, dual coil, you'll have to go higher gauge wire.

I have a tugboat, similar post design to the doge, and I don't use it on the mini if I build dual coils, even though I rarely run it above 30 watts anymore on more powerful devices.