ipv2 mini/doge rda

[TkayIs300]

Hey guys! hope everyones day is going well, i have another problem i am looking for solutions to, every puff i take the volts/ohms seem to bounce around all over the place, whenever it stays steady it is around .5ohms/5.5volts, but it can go all the way up to .8/1.8 give or take, i have no idea what could be causing this and it is very annoying because the strength of the hit is so unpredictable, any feedback is appreciated and i would love to know if there is anything i can do to fix this problem, thanks guys! happy vaping.
-Taylor

 

[roxynoodle]

This is actually the problem, not your wicking I'm afraid.

Check:

1. Post screws are tight
2. Cut leads aren't touching other posts or the top cap
3. coils aren't touching posts or the top cap
4. 510 pin on atty isn't wobbling around
5. Positive post in atty is tight

 

[kswolf77]

If you have a loose lead/post or the atty isn't making a solid connection it makes sense that it would raise the resistance, and therefore the voltage. I doubt it's a coil touching as that should lower the resistance, but electronics do funny things when there is a short or a bad connection. roxynoodle's suggestions are all on par.

 

[TkayIs300]

ya i checked and two of my posts were loose, and i moved one coil farther away from the center post bc it was nearly touching and it seems to be holding solid at .5/5.1 so far! thanks for helping me step my vape game up to the next level haha, good vapes!
-Taylor

 

[roxynoodle]

Awesome! Oh, and welcome