IPV4 not reading ohms

[Edd Harbin]

Just got an ipv4 and Ni200 28 gauge wire . I built a duel coil 28 gauge build , checked it on my ohm tester... 0.1 ohm . Stick it in the ipv4 and it reads *.53 ohms . Built another build , same thing ....what is up ? It reads correct in power mode with Kantian builds .

 

[Edd Harbin]

Just got an ipv4 and Ni200 28 gauge wire . I built a duel coil 28 gauge build , checked it on my ohm tester... 0.1 ohm . Stick it in the IPV4 and it reads *.53 ohms . Built another build , same thing ....what is up ? It reads correct in power mode with Kantian builds .

 

[Edd Harbin]

Never mind .... Forgot to turn off IDIOT mode and didn't set the resistance .

 

[Wraith504]

ive noticed the readings dont change until after you hit the power button.

 

[Edd Harbin]

Actually , when you set the Temp you must hit both up and down buttons simultaneously to "set" the resistance .