Is it normal ?
- Thread starter JOE1974
- Start date
- th_trl_thread_readers 0
- Status
Mine does the same... Not on every atomizer, only a couple of them...
It will read some ridiculously low reading, then jump to an accurate reading... That may be due to how it reads the resistance... It's placing a load on it, perhaps that first split second the coil is in the process of heating up
It will read some ridiculously low reading, then jump to an accurate reading... That may be due to how it reads the resistance... It's placing a load on it, perhaps that first split second the coil is in the process of heating up
Mine does that too. Takes a second to stablize, I think. I tend to check it twice just to make sure the number is accurate.
It's totally normal. You should hear it fire a little when it's checking. It does that to give you a accurate reading of the actual ohm while vaping.
- Status
Similar threads
- Locked
