Itaste svd wont fire with stacked 18350s

[Tripod219]

I picked up a set of eh imr 18350 for my svd. Charged them up and they worked like a champ. Tried to use them today after a charge and I get lov (low voltage) on the display. I checked them and is showing 8.5v. I don't get why my 18650 works just fine. Any suggestions?

Sent from my SCH-I545 using Tapatalk

 

[Switched]

The SVD is designed to use a single cells not stacked batteries. It is protecting itself. There is ABSOLUTELY no reason for using stacked batteries these days with VV or VW devices.

 

[Burnie]

iTaste SVD USER MANUAL - Best Electronic Cigarette | E Cigarette Manufacturer|Best Vape MOD| Innokin

Note: Before you switch between one battery and two batteries configurations, please hold the “+ & - ” button for 5 seconds to release the remaining power in the circuit board. (when you make a switch from one battery to two batteries, the circuit board will keep the single battery settings if you haven’t released the remaining capacity; and vice versa.)

also here
http://www.e-cigarette-forum.com/fo...520450-thread-innokin-svd-9.html#post12356387

Try removing the battery and then holding the + and - buttons simultaneously for 5 seconds or so. That's how you reset going from stacked to single, so maybe it will also reset the protection circuit.

Hope that helps

Vape On
Burnie

 

[Switched]

iTaste SVD USER MANUAL - Best Electronic Cigarette | E Cigarette Manufacturer|Best Vape MOD| Innokin



also here
http://www.e-cigarette-forum.com/fo...520450-thread-innokin-svd-9.html#post12356387



Hope that helps

Vape On
Burnie

Interesting, I didn't know that. Nonetheless there still is no reason toe stack batteries these days. SAFETY!

 

[Tripod219]

I held the 2 buttons down and installed the batteries. Fired up like a champ. Now I can hit the upper range of the device. Thanks for the help

Sent from my SCH-I545 using Tapatalk