I tried sub-ohming for the first time on my kanger aero tank. I got it to read .5 but it wouldn't fire. I read that the VTR won't fire anything under .6 so I wasn't surprised. I got it to read .7 and it would fire but shorted out afterwards. After another coil rebuild. It read 1ohm. When I tried to fire it, it would fire but then the ohm reading started jumping all over the place like from 1 ohm to 2 to 3 then back down to under 1 ohm. The VTR was getting hot so I left it alone for a while but when I tried to fire it again, the light would come on but doesn't heat up the coil. I tried switching out the clearomizer with another one that was all stock and same thing happened. I used kanthal 24 to build a single coil with organic cotton. The VTR could still read the ohms but it just doesn't output any power. I tried swapping batteries as well. I think I fried something. Anyone have a similar experience or know what I can do to fix this issue? The last thing I want to do is buy a new unit.
Before I get preached on sub ohming and the safety hazards, I read afterwards how dangerous it is. Yes I know now how dangerous it could be because if I shorted this on a unregulated mod, I probably would've had bigger problems. Any help and advice is appreciated though.
Before I get preached on sub ohming and the safety hazards, I read afterwards how dangerous it is. Yes I know now how dangerous it could be because if I shorted this on a unregulated mod, I probably would've had bigger problems. Any help and advice is appreciated though.
