itaste vv problems

Status
Not open for further replies.
I currently own two itaste vv. My silver one works fine with the tank giving me more issues then anything, sometimes but i get thme resolved quickly. My black one will not give me the results im looking for. It doesn't give enough vapor and i tend to suck on it more for a lot less vaper. I have them set on the exact same settings and i normally switch the tanks between the two batteries. I have noticed that from my ohms on my silver it reads and 1.9 and on the black it reads a 2.1 for a atomizer ohms of 1.8. i have learned as the ohms go up that means that the atomizer is going bad but i don't think that is the problem here. Any suggestions on what could be wrong with my black one. i have had to take it apart a few times and put the wires back in the correct spots and sorts but this last time that was not the issue. Not sure whats wrong. They are the exact same battery.
 
Try thoroughly cleaning the inside of the 510 connector on the v3 with a qtip and some Iso Alcohol, maybe you're getting a bit higher resistance reading due to buildup on the contacts.

I've tried cleaning everything last night it was reading a higher ohms at around 4.7-5.4 for a 1.8 which normally reads 1.9. its not the atomizer. i took it apart last night and the wires had come lose again i put them back together i kind of think it needs to be sawdered back together.

Has anyone else has these kinds of problems with the itaste vv v3?
 

tchavei

Vaping Master
ECF Veteran
Verified Member
Jul 15, 2014
4,765
8,710
Portugal
Didn't even know you could open them...

Anyway, I have one and it reads pretty accurate although I haven't figured out why it sometimes rounds up and sometimes down. A 1.19 ohm coil reads as 1.2 but a 1.47 ohm coil reads as 1.4. On the other hand, other mod's also aren't that great either but at least consistent (evic always rounds down and zMax always up, at least mines)


Regards
Tony

Sent from my GT-I9195 through Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread