Ithaka wick size

[souroull]

Good evening guys,

I'm running out of wick for the Ithaka and would like to place an order for some. Problem is, i'm not sure what the stock wick size is for the Ithaka. (if not stock, the optimal size)

Any input? I'm vaping on low ohmage (0.5-0.75ohm)

Thx!

 

[fright88]

I am using cotton now but with Silica I prefer 2.5mm with full wick in each channel 2 pieces up top. Less wick in the channels seems to wick better for me. But I believe it was 3 or 3.5 mm included with ithakas.

 

[souroull]

I have some 3.5mm left over from my ody days but it's way too thick for the Ithaka channels.

The stock wick was looking like a 2mm but not sure

 

[imeothanasis]

wick that came with Ithaka was 3mm but on Ithaka and Ody I prefere 2-2,5mm sour

 

[Itshak]

I use on the old rebuildable atty 2 wicks of 2mm running down the channels,
And top them with 1 3mm wick on the resistance part only cut on the beginning of the channels.
I found this to work the best.
So I keep both 3mm and 2mm in my stock.

 

[justinred]

I have some 3.5mm left over from my ody days but it's way too thick for the Ithaka channels.

The stock wick was looking like a 2mm but not sure

You can just remove some strands from the wick to make it smaller. Example is 3.5mm from esmoke is 9 strands so remove 4 strands to make it approximately 2mm.

 

[tmccooljr]

It always depends on the build. Get allot of everything and find your sweet spot.

 

[tmccooljr]

1mm can be allot of fun too and is often over looked.