its official

[jason25366]

100 percent VG ruins my clearomizers i was vaping 70/30 earlier and it was all good never got burnt or anything then i put my 100 percent vg in the new clearmoizer i got, put it on it side waited like 30 min before vaping twirled it around to make sure it was nice and soaked started vaping and after the 10th hit BOOM burnt taste whats the secret i need to know about 100 percent vg

 

[Joshua Grench Moffett]

Is it a high acidic liquid? Like cinnamon or red hot? Depending on what your clearomizer is made out of it could mess it up.

 

[Rainocig]

I'm using 100% VG in Kanger t3 and it wicks fine. I did notice the 100% VG from ecblends is thinner than some of the mixed juice I have from other places.

 

[jason25366]

nope its just regular watermelon

 

[jfalbanese]

i don't know much about this stuff, but i bet you would be better off with an atomizer if you are going 100% VG. not a big fan of VG myself.

 

[niczgreat]

I vape with VG only. I make my own e-liquid.
No problem with clearomizers.

The secret is to add purified water to the liquid until it
has the consistency of a Pg blend.

It isn't meant to be vaped at higher voltages.
The maximum I can go on a Vg Liquid is 4.4v on a 2.4ohm Clearomizer. And pretty much
I'm usually at around 4.0-4.2

 

[jadam23]

Same here with carto tanks, just too thick. I use a 50/50 blend now.

 

[DJ RyckRak]

Good advice Tom !