Ivogo KFL Mini: post screw problem

[proax9]

I been building coils for my EHPRO KFL lite+ rba without any issues.
Just received an Ivogo KFL mini.

On the mini:
It seems the screws for attaching the coil must be rounded on the bottom (I guess?).
No matter how I hold the wire, when I tighten the screw- the wire gets pushed out.
(Screw does not hold the wire down.)

Anyone else have this problem, or better yet- a solution?

 

[doots]

I have one too and have to wrap your wire all the way around the screw for it to hold.. try that and then tighten them down. works good.. screws are very small.