Joye 510 Cartomizer Question

[BigJohnJ]

I have a couple of questions I guess concerning the new Joye 510 cartomizers.

1) The supplier said that they are Joye 510's. but not branded so how does one know for sure that they are truely Joye?

2) I have watched the video's on how to fill them. Have to poke the needle or paperclip down the center to break open a seal prior to using the needle to fill. Is this seal down inside the center tube that you see when you remove the end cap and the second plug thing with the two little holes.

That is what I did when I filled one the first time then used the needle down the center tube to fill. only got a little over .5ml before it started dripping out the battery end.

Sure would be thankful for any help on filling these new cartomizers.

John

 

[upStomp]

From your description, they are Joye 510's. I'm not aware of any knockoffs with the same configuration.

Yes, it sounds like you've correctly identified and punctured the fill nozzle.

You should be able to get about .8ml on your first fill. You may be pushing the needle too deep into the filling. You should only push the needle in until you start to feel resistance, then fill slowly while holding at a 45 degree angle, rotating the carto. The idea is to fill from the top of the filling down. If you fill the bottom first, you'll get leakage and not properly soak the filling.

 

[BigJohnJ]

Ok, cool thanks, yes I did push the needle down as far as it would go. Makes sense now that it should be filled from top down.