Jumping ohms

[shironeko]

Can anyone tell me why my ohms would suddenly start jumping on an RDA?

Built a 1ohm single coil build in a tesla DII. Used 26 kanthal at around 8 wraps. Was firing OK yesterday (got a few "check atomizer" warnings from my Hana clone 30w, but unscrewing and replacing got it to work)

Was working fine earlier, then added some more juice, got a "check atomizer" warning again, unscrewed and replaced and ohms were jumping between 2 and 2.4 ohms on each fire. Put kayfun clone on the Hana clone (yes, I know, a lot of clones) the kayfun has a 1.6 build, everything stayed constant.

Put the RDA on my MVP 2.0, just to get an ohms reading (the atty would fire, slowly) and I was getting readings of 2.2 to 2.4

At first I thought it was a janky Hana clone issue (it kind of rebooted a few times) but I'm getting the same ohms on both.

Any ideas folks?
Also, what's the rebooting of the Hana clone all about?

Thanks in advance folks.

 

[Ryedan]

The first thing I would do in this case is tighten the wires in the posts and see if that helped. I bet you'll find them a bit loose.

No idea about the Hana.

 

[havinfun1]

+1 on what Ryedan says. I would also check the 510 connection if it is adjustable, on both the Hana & atomizer.

 

[shironeko]

You guys are gurus!!! Just checked the posts now and my negative post was pretty loose (how that happened I don't know!)

Thanks guys!!!!!

 

[Rule62]

You guys are gurus!!! Just checked the posts now and my negative post was pretty loose (how that happened I don't know!)

Thanks guys!!!!!

Sometimes, after the coil has heated and cooled a few times, the screws will need to be re tightened. Whenever you set up a coil, always recheck the screws after you've fired the coil.


Sent from my iPad using Tapatalk