Kanger mt3 cleaning?

[kirstinr]

I just received my new setup today(second set this week - yay!) and want to try some of the ejuice I bought. I've searched all the obvious places - google, YouTube and here but I can't find any real info on cleaning the mt3. Do I just need to rinse and dry between ejuices, or do I need to go in depth, i.e. alcohol rinse, water, hot water or whatnot. What is the best way to go about moving between different juices so I get the full taste of each one?

TIA,
Kirstin

 

[Renzuli]

Welcome , and if your staying with similar juices , a quick warm water rinse , is all that's needed . If on the other hand , your changing say from a tobacco , to a fruit flavor , you might have to do a bit better job of cleaning . But even if you do a quick rinse , dry it , and maybe do a dry burn , to get the crud , off the coil , you can change juices . After awhile the new juice will sort of take over , and mask the previous juice . Good Luck

 

[justice92786]

I clean mine out about every three juices. I rinse the head and tank with warm water, dry both with paper towel, and let sit over night. In the morning I remove the head center shaft and the two flavor wicks and give it a few dry burns. When I dry burn I do it about 5-10 fires (depending on the looks of the coil) at 3 seconds a piece. When the coil glows evenly you're good to go.

 

[ms277017]

Man I use Everclear to clean nearly all of my e-cig stuff, cheap vodka works well too IMO.