The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Kanger sub box mini issues

Discussion in 'Ask The Veterans' started by Tom wilkinson, May 27, 2016.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Tom wilkinson

    Tom wilkinson New Member

    May 27, 2016
    So I've had a kanger for a while now and it was working fine for a couple of months. Then I left it in a desk drawer for a few months. Now it won't turn on even when charging and the screen stays black all the time. How can I fix it?
     
  2. DavidOck

    DavidOck ECF Guru ECF Veteran

    Supporting member
    Don't have one, so maybe sort of "general" info...

    Try a different 18650, and charge outside the mod - i.e. don't use the USB charge port. If the battery is too low, it could take a long time for it to charge (if at all!), especially with on-board charging. With many regulated mods, there's a small drain on the battery even when no display is lit. Over time, that can yield a "dead" battery.

    Make sure the battery polarity is correct for the mod. If in backwards, it won't power up. (And some don't have reverse polarity protection, putting it in backwards will result in failure. Yours says it does, so just won't power up if backwards.)

    Good luck!
     
    • Like Like x 1
Thread Status:
Not open for further replies.

Share This Page