Kayfun lite clone and mvp v2 problem

[Neil7289]

My kayfun lite reads 2.5ohm on my ohm checker when fully tightened down but when I put it on my mvp the ohms just keep changing depending on how tight it is, when I fully tighten it down it reads a lot higher than 2.5ohms, does anyone know what the problem is?

 

[Susan~S]

Sounds like your MVP's center pin is not making good contact with the atomizer connection. This usually occurs from over-tightening the tank onto the battery connector.

Center Pin Issue - Fixing a non firing eGo battery

 

[joesquid]

Agree with Susan. Never "fully" tighten any tank on an MVP. Only screw down until you feel a little resistance.