I have had a kayfun lite plus authentic for 3 or 4 months. All of a sudden no matter what I put in there it will vape fine for an hr or so and then I get a horrible burnt hit and the ohms go up. If I use it again the ohms go back down and its fine? What could this be? I have taken the base off and checked the plastic it looks good.
Kayfun Lite Problem!
- Thread starter paulb787
- Start date
- th_trl_thread_readers 0
- Status
What's the setup like? What kind of coil, what ohms, what kind of wicking. what battery/mod are you using. From your description of "all of a sudden" I surmise that it used to work fine... Ohms tend to go up when the coil shorts; the fact that it comes back down on it's own implies a "temporary"short (something happening once the atty is hot but not before)
A 'short' will decrease the resistance.
A loose or 'dirty' connection will cause an increase in resistance.
I agree with iamthevoice, that you have not provided much info.
My suggestion would be to begin by totally disassembling your kayfun, clean each and every part, replace the coil and wick, re assembel ensuring that all electrical connections are tight. Next clean the 510 connector on your battery (PV).
A loose or 'dirty' connection will cause an increase in resistance.
I agree with iamthevoice, that you have not provided much info.
My suggestion would be to begin by totally disassembling your kayfun, clean each and every part, replace the coil and wick, re assembel ensuring that all electrical connections are tight. Next clean the 510 connector on your battery (PV).
I had exactly the same issue with mine a couple of weeks ago. I went through several coils and changed wicking numerous times. After some research and Google searches I did what the previous posters suggest. I tore it down completely and cleaned everything with some soap and warm water. I left it to dry overnight and built a new coil the next day and haven't had a problem since. I think things just get a little gunked up after a while and a good cleaning is in order to get rid of the buildup. Give it a try and see how it works out. Good luck!
I know its not the coil. I use cotton wicking. I have taken the base apart and seems ok. I am using it on the ipv2 (maybe its that).. It will jump in ohms (always higher) for one hit and the go right back to normal. Its like Russian roulette .. when is a disgusting hit coming. Thanks 4 replys. I am going to do the soap thing
- Status
Similar threads
- Locked
