Kayfun lite + with itaste vv v3?

[Zanzabar78]

Hello everyone,

I have a couple of itaste vv v3, and was wondering if it could power the kayfun lite + reliably.

I know a higher end mod would be better but for many reasons i'm stuck with the itaste for now.

Thank you in advance

 

[Conchord George]

Not sure what the official low limit is on a VV but I've had 1.5 ohm atomizers on it no problem. As long as you keep the resistance above the limit it should work fine. Might look a little goofy but will vape good

 

[Zanzabar78]

Not sure what the official low limit is on a VV but I've had 1.5 ohm atomizers on it no problem. As long as you keep the resistance above the limit it should work fine. Might look a little goofy but will vape good

Thanks for the quick reply, one more question: do i have to get an ohm meter? or would the test resistance function on the itaste suffice , thanks again

 

[thegcpu]

It will fire it if you have a resistance higher than 1.5 ohms, but it will be way to top heavy and look awful!

Here is what it looks like. And mind you that this Kayfun even has a K-NaNo kit..

Hers it what a Kufun should look like!

 

[Conchord George]

Thanks for the quick reply, one more question: do i have to get an ohm meter? or would the test resistance function on the itaste suffice , thanks again

No, the ohm check function on the VVs works great. I check the resistance on all my rebuildables with my MVP which is basically the VV's big brother. Good luck!

 

[Zanzabar78]

Thanks again you've been a great help, much appreciated